Suzuki Grand Vitara 2011 Manual page 962

3B-17 Differential: Front
26) Apply grease to oil seal lip, and then install oil seal
into differential side right retainer (1) as shown in
figure.
Distance between retainer surface and oil seal
"a": 0.65 – 1.65 mm (0.026 – 0.065 in.)
"A": Grease 99000–25010 (SUZUKI Super
Grease A)
Special tool
(A): 09913–75520
27) Clean mating surface of right retainer, carrier (1) and
rear cover (2), apply sealant to carrier and rear cover
as shown in figure by such amount that its section is
1.5 mm (0.059 in.) in diameter, mate right retainer
with carrier and rear cover, and then tighten bolts to
specified torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Retainer bolt: 50 N·m (5.0 kgf-m, 36.5 lb-ft)
2
28) Clean mating surface of front drive shaft retainer,
29) Install front drive shaft using plastic hammer.
30) Install front differential rear mounting (1).
I5JB0A321045-01
31) Install front differential right mounting (1).
"A"
1
I5JB0A321048-01
carrier (1) and rear cover (2), apply sealant to carrier
and rear cover as shown in figure by such amount
that its section is 1.5 mm (0.059 in.) in diameter,
mate front drive shaft retainer with carrier and rear
cover, and then tighten bolts to specified torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Retainer bolt: 50 N·m (5.0 kgf-m, 36.5 lb-ft)
1
Tightening torque
Rear mounting bracket bolt (a): 50 N·m (5.0 kgf-
m, 36.5 lb-ft)
1
Tightening torque
Right mounting bracket bolt (b): 50 N·m (5.0 kgf-
m, 36.5 lb-ft)
2
"A"
I5JB0A322014-01
(a)
I5JB0A321046-01
1
(b)
I5JB0A321047-02