Dtc P2119: Throttle Actuator Control Throttle Body Range / Performance - Suzuki Grand Vitara 2011 Manual

DTC P2119: Throttle Actuator Control Throttle Body Range / Performance

Wiring Diagram
Refer to "DTC P2101: Throttle Actuator Control Motor Circuit Range / Performance: For Petrol Engine Model".
DTC Detecting Condition and Trouble Area
DTC detecting condition
Difference between the measured (actual) throttle valve
opening angle and the target throttle valve opening angle
which is calculated based on accelerator pedal opening
angle and engine condition is more than specification for
specified time continuously.
(1 driving detection logic)
DTC Confirmation Procedure
1) With ignition switch turned OFF, connect scan tool.
2) Turn ON ignition switch and clear DTC using scan tool.
3) Keep the accelerator pedal at idle position for 2 seconds.
4) Keep the accelerator pedal at fully depressed position for 2 seconds.
5) Repeat Step 3) and 4) for 3 times.
6) Check DTC.
DTC Troubleshooting
NOTE
Before this trouble shooting is performed, read the precautions for DTC troubleshooting referring to
"Precautions for DTC Troubleshooting: For Petrol Engine Model".
Step
1 Was "Engine and Emission Control System Check"
performed?
2 Electric throttle body assembly system check
1) Connect scan tool to DLC with ignition switch turned
OFF.
2) Turn ON ignition switch, check each voltage of "TP
Sensor 1 Volt" and "TP Sensor 2 Volt" displayed on scan
tool when accelerator pedal is idle position and fully
depressed.
Is displayed each TP sensor value as described voltage in
"Scan Tool Data: For Petrol Engine Model"?
Engine General Information and Diagnosis: For Petrol Engine Model 1A-200
Action
Trouble area
• Throttle actuator circuit
• Electric throttle body assembly
• ECM
Yes
Go to Step 2.
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection in Section
00".
S6JB0A1114072
No
Go to "Engine and
Emission Control
System Check: For
Petrol Engine Model".
Go to Step 3.