Fuel Pressure Relief Procedure; Fuel Leakage Check Procedure - Suzuki Grand Vitara 2011 Manual

1G-29 Fuel System: For Diesel Engine Model
3. Gasket
4. Fuel pump assembly plate
5. Main fuel level gauge
6. Sub fuel level gauge
7. Fuel tank belt
8. Fuel feed line
9. Fuel return line
10. Priming pump
11. Fuel filter case
12. Fuel filter

Fuel Pressure Relief Procedure

1) Check that engine is cold.
2) Connect SUZUKI scan tool to DLC (1) with ignition
switch turned OFF.
Special tool
(A): SUZUKI scan tool
(A)
3) Turn ON ignition switch.
4) Confirm that fuel high pressure line is not under
pressure by using "Fuel Rail Pressure" under "Data
List" of SUZUKI scan tool.
15. Fuel filter water detection sensor
16. Injection pump
: For detail of component, refer to "Injection Pump
Components: For Diesel Engine Model".
17. High pressure pipe between injection pump and common
18. Common rail
19. Common rail cover
20. Common rail cushion
21. High pressure pipe between common rail and fuel injector
22. Fuel injector
23. Fuel injector bracket
24. Fuel injector return hose
S6JB0A1726002
1
I5JB0A110019-01
27. To fuel injector return hose
28. To high pressure pipe between common rail and
injection pump
29. To common rail
30. Sealing washer
31. To fuel return line
: 11 N⋅m (1.1 kgf-m, 8.0 lb-ft)
: 50 N⋅m (5.0 kgf-m, 36.5 lb-ft)
: 5 N⋅m (0.5 kgf-m, 4.0 lb-ft)
: 22 N⋅m (2.2 kgf-m, 16.0 lb-ft)
: 25 N⋅m (2.5 kgf-m, 18.5 lb-ft)

Fuel Leakage Check Procedure

1) Prime fuel line using priming pump (1).
1
2) Check low pressure fuel supply circuit for fuel
leakage.
3) Start engine and run it at idle speed for about 10
seconds.
4) Stop engine and then check for fuel leakage in each
part, which was serviced.
5) Start engine and run it at 4,000 r/min. for about 10
seconds.
6) Stop engine and then check for fuel leakage in each
part, which was serviced.
S6JB0A1726003
I5JB0B170002-01