Dtc P0106: Manifold Absolute Pressure Range / Performance - Suzuki Grand Vitara 2011 Manual

Hide thumbs Also See for Grand Vitara 2011:

Table of Contents

DTC P0106: Manifold Absolute Pressure Range / Performance

Wiring Diagram

1. Manifold absolute pressure sensor

2. To electric load current sensor (for J20 engine) and A/C refrigerant pressure

sensor (if equipped with A/C)

DTC Detecting Condition and Trouble Area

DTC detecting condition

• Difference between Max. manifold absolute pressure

value and Min. manifold pressure value is less than 1.3

kPa (0.19 psi) when engine running at idle speed.

• Difference between barometric pressure value and

manifold pressure value is less than 33.3 kPa (4.83 psi)

for 5 sec. at 2000 r/min. or more.

(2 driving cycle detection logic)

DTC Confirmation Procedure

Check to make sure that the following conditions are satisfied when using this "DTC Confirmation

• Intake air temperature at engine start: –10 °C (14 °F) to 80 °C (176 °F)

• Intake air temperature: –10 °C (14 °F) to 70 °C (158 °F)

• Engine coolant temperature: 70 °C (158 °F) to 150 °C (302 °F)

• Altitude (barometric pressure): 2400 m, 8000 ft or less (560 mmHg, 75 kPa or more)

1) Connect scan tool to DLC with ignition switch OFF.

2) Turn ON ignition switch and clear DTC using scan tool and warm up engine completely.

3) Run engine at idle speed for 1 min.

4) Check DTC and pending DTC.

Engine General Information and Diagnosis: For Petrol Engine Model 1A-86

• Manifold absolute pressure sensor

• Manifold absolute pressure sensor vacuum passage

• Air intake system

C37-30 BLK/ORN

3. To other sensors

Trouble area

S6JB0A1114021

I5JB0A110034-01

Table of Contents