Oil Pump Components; Oil Pump Removal And Installation - Suzuki Grand Vitara 2011 Manual

1E-17 Engine Lubrication System: For J20 Engine

Oil Pump Components

1. Cylinder block
2. Oil pump relief valve set
: Replace as a set.
3. Baffle plate
4. Pin No.1
5. Pin No.2

Oil Pump Removal and Installation

CAUTION
!
Don't remove sprocket and inner rotor from
oil pump, otherwise damage of oil pump
center shaft and abnormal operation of oil
pump could result.
Removal
1) Disconnect negative cable at battery.
2) Drain engine oil referring to "Engine Oil and Filter
Change (Petrol Engine Model) in Section 0B".
3) Remove oil pan and oil pump strainer.
Refer to "Oil Pan and Oil Pump Strainer Removal
and Installation: For J20 Engine".
6. Oil pump mounting bolt (M8 bolt)
7. Oil pump case bolt
8. Oil pump relief valve retainer
9. Oil pump chain guide
10. Oil pump chain guide plate
S6JB0A1526005
11. Oil pump chain guide nut
12. Oil pump case No.1
13. Oil pump case No.2
14. Pin No.3
15. Baffle plate bolt (M6 bolt)
4) Remove baffle plate from lower crank case (1).
5) Remove oil pump chain guide.
6) Remove oil pump (2) with sprocket from lower crank
case (1).
S6JB0A1526004
I5JB0A152010-02
: 25 N⋅m (2.5 kgf-m, 18.0 lb-ft)
: 12 N⋅m (1.2 kgf-m, 9.0 lb-ft)
: 28 N⋅m (2.5 kgf-m, 20.5 lb-ft)
: 11 N⋅m (1.1 kgf-m, 8.0 lb-ft)
: 11 N⋅m (1.1 kgf-m, 8.0 lb-ft)
I2RH01150016-01