Crankshaft Position (Ckp) Sensor Removal And Installation - Suzuki Grand Vitara 2011 Manual

1C-12 Engine Electrical Devices: For Petrol Engine Model
Crankshaft Position (CKP) Sensor Removal and
Installation
For J20 Engine
Removal
1) Remove transmission assembly from vehicle
referring to "Automatic Transmission Assembly
Dismounting and Remounting in Section 5A" or
"Manual Transmission Assembly Dismounting and
Remounting: For Petrol Engine Model in Section
5B""Manual Transmission Assembly Dismounting
and Remounting: For Petrol Engine Model in Section
5B".
2) Remove drive plate or flywheel from crankshaft.
3) Disconnect connector from crankshaft position
sensor.
4) Remove crankshaft position sensor (1) from cylinder
block (2).
Installation
Reverse removal procedure noting the following.
• Apply engine oil to O-ring of sensor.
• Tighten CKP sensor bolt to specified torque.
Tightening torque
CKP sensor bolt (a): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
• Connect connector and fix wire harness with clamp
securely.
For M16 Engine
Removal
S6JB0A1316015
1) Disconnect negative cable at battery.
2) Remove generator drive belt, loosen pivot bolt and
move generator outward.
3) Disconnect connector from crankshaft position
sensor.
4) Remove crankshaft position sensor (1) from cylinder
block.
Installation
1) Install crankshaft position sensor to cylinder block.
Tighten CKP sensor bolt to specified torque.
Tightening torque
CKP sensor bolt (a): 10 N·m (1.0 kgf-m, 7.5 lb-ft)
2) Connect connector to CKP sensor securely.
3) Adjust generator drive belt tension referring to
I2RH01130021-01 "Water Pump and Generator Drive Belt Tension
Inspection and Adjustment (For M16 Engine): For
Petrol Engine Model in Section 1J".
4) Connect negative cable to battery.
I2RH0B130012-01
(a)
I5JB0A130028-01