Water Pump Inspection; Specifications; Tightening Torque Specifications; Special Tools And Equipment - Suzuki Grand Vitara 2011 Manual

1F-13 Engine Cooling System: For Petrol Engine Model
5) Disconnect heater pipe (2) from water pump (1).
6) Remove water pump (1) from cylinder block (3).
Installation
Reverse removal procedure for installation noting the
following points.
• Use new O-ring when installing.
• Install water pump assembly to cylinder block and
tighten bolts to specified torque.

Tightening Torque Specifications

Fastening part
Water pump bolt and nut
Water pump bolt
NOTE
The specified tightening torque is also described in the following.
"Cooling System Components: For Petrol Engine Model"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fastener Information in Section 0A".

Recommended Service Material

Material
Water tight sealant
I5JB0A161016-01

Specifications

Special Tools and Equipment

SUZUKI recommended product or Specification
SUZUKI Bond No.1207F
Tightening torque
Water pump bolt: 25 N·m (2.5 kgf-m, 18.0 lb-ft)
• Refill cooling system referring to Step 7) to 17) of
"Cooling System Flush and Refill: For Petrol Engine
Model".
• Verify that there is no coolant leakage at each
connection.

Water Pump Inspection

CAUTION
!
Do not disassemble water pump.
If any repair is required on pump, replace it
as assembly.
Rotate water pump by hand to check for smooth
operation. If pump does not rotate smoothly or makes
abnormal noise, replace it.
Tightening torque
N⋅m kgf-m
25 2.5
25 2.5
P/No.: 99000–31250
S6JB0A1616017
I2RH0B160019-01
S6JB0A1617001
Note
lb-ft
18.0
18.0
S6JB0A1618001
Note