Dtc Table - Suzuki Grand Vitara 2011 Manual

Using Diagnosis Connector
1) Turn ignition switch to ON position.
2) Using service wire short diagnosis switch terminal
(1) of diagnosis connector (2) and body ground more
than 5 times at about 1 second interval within 10
seconds.
3) Wait more than 9 seconds.
4) Perform "DTC Check: Motor-Shift Type (Transfer
with Shift Actuator)" and confirm that DTC No. is not
displayed.

DTC Table

DTC No.
C1213 Transfer switch circuit open
C1214 Transfer switch circuit short
Transfer shift actuator motor
C1223
position switch 1 circuit open
Transfer shift actuator motor
C1224
position switch 1 circuit short
C1227 4L/N switch circuit open
C1228 4L/N switch circuit short
Transfer actuator circuit
C1230
malfunction
Transfer shift actuator motor
C1235
position switch 2 circuit open
Transfer shift actuator motor
C1236
position switch 2 circuit short
Center differential lock switch
C1237
circuit open
Center differential lock switch
C1238
circuit short
4WD control module power
C1240
supply circuit malfunction
Transfer: Motor-Shift Type (Transfer with Shift Actuator) 3C-22
Detecting item
1
Detecting condition
(DTC will set when detecting)
Different switch combination from specification is
detected.
Different switch combination from specification is
detected.
Actuator position switch signal voltage 4.2 V or
more.
Actuator position switch signal voltage 0.6 V or
less.
Though actuator position switch is "4L-lock"
position, the ON signal is not input from the 4L/N
switch.
Though actuator position switch is "4L-lock"
position, the OFF signal is not input from the 4L/
N switch.
• Position switch in transfer shift actuator is not
changed for 3 seconds even if command
signal of motor relay for transfer shift actuator
(included in 4WD control module) is turned on.
or
• Monitor signal from motor relay of transfer
shift actuator (included in 4WD control
module) is inconsistent with command signal
to motor relay of transfer shift actuator.
Actuator position switch signal voltage 4.2 V or
more.
Actuator position switch signal voltage 0.6 V or
less.
Though actuator position switch is "4H" position,
the ON signal is not input from the center
differential lock switch.
Though actuator position switch is "4L-lock"
position, the OFF signal is not input from the
center differential lock switch.
Battery voltage is lower than lower limit voltage
for 4WD control module diagnosis.
2
I5JB0A332014-01
S6JB0A3314007
Transfer
position
indicators