Dtc P0112: Intake Air Temperature Sensor Circuit Low - Suzuki Grand Vitara 2011 Manual

1A-93 Engine General Information and Diagnosis: For Petrol Engine Model
Step
5 Wire circuit check
1) Disconnect connectors from ECM with ignition switch
turned OFF.
2) Measure resistance between "LT GRN" wire terminal of
MAF and IAT sensor connector and vehicle body
ground.
Is resistance infinity?
6 Wire circuit check
1) Turn ignition switch to ON position.
2) Measure voltage between "LT GRN" wire terminal of
MAF and IAT sensor connector and vehicle body
ground.
Is voltage about 0 V?
7 Wire circuit check
1) Measure resistance between "C37-25" terminal of ECM
connector and "LT GRN" wire terminal of MAF and IAT
sensor connector with ignition switch turned OFF.
Is resistance below 3
8 Ground circuit check
1) Connect connectors to ECM.
2) Check for proper connection of MAF and IAT sensor
connector at "GRY/GRN" wire terminal.
3) Measure resistance between "GRY/GRN" wire terminal
of MAF and IAT sensor connector and vehicle body
ground with ignition switch turned OFF.
Is resistance below 5
9 Ground circuit check
1) Remove ECM from its bracket with ECM connectors
connected.
2) Measure resistance between "C37-57" terminal of ECM
connector and vehicle body ground.
Is resistance below 3
10 IAT sensor check
1) Check IAT sensor according to "Mass Air Flow (MAF)
and Intake Air Temperature (IAT) Sensor Inspection: For
Petrol Engine Model in Section 1C".
Is it in good condition?

DTC P0112: Intake Air Temperature Sensor Circuit Low

Wiring Diagram
Refer to "DTC P0111: Intake Air Temperature Circuit Range / Performance: For Petrol Engine Model".
DTC Detecting Condition and Trouble Area
DTC detecting condition
Voltage of IAT sensor output is less than 0.2 V for 0.5 sec
continuously (High intake air temperature (low voltage / low
resistance))
(1 driving cycle detection logic)
Action
Ω
?
Ω
?
Ω
?
Yes
Go to Step 6.
Go to Step 7.
Go to Step 8.
Go to Step 10.
"GRY/GRN" wire is
open or high resistance
circuit.
Poor "C37-57"
connection.
Substitute a known-
good ECM and recheck.
Trouble area
• IAT sensor circuit
• IAT sensor
• ECM
No
"LT GRN" wire is
shorted to ground or
other circuit.
If wire is OK, substitute
a known-good ECM and
recheck.
"LT GRN" wire shorted
to other circuit.
If wire is OK, substitute
a known-good ECM and
recheck.
"LT GRN" wire is high
resistance circuit.
Go to Step 9.
Faulty ECM ground
circuit.
If circuit is OK,
substitute a known-
good ECM and recheck.
Replace MAF and IAT
sensor.
S6JB0A1114025