1C-30 Engine Electrical Devices: For Diesel Engine Model
Installation
Reverse removal procedure for installation noting the
following.
• Clean CKP sensor and sensor rotor teeth before
installation.
• Tighten CKP sensor bolt to specified torque.
Tightening torque
CKP sensor bolt (a): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
Crankshaft Position (CKP) (Engine Speed
Sensor) Sensor Inspection
1) Remove CKP sensor referring to "Crankshaft
Position (CKP) Sensor (Engine Speed Sensor)
Removal and Installation: For Diesel Engine Model".
2) Check that CKP sensor (1) and sensor rotor tooth (2)
are free from any metal particles and damage.
3) Check that resistance between terminals of CKP
sensor is within specification.
If resistance is not as specified, replace CKP sensor.
CKP sensor resistance
612 – 880 Ω at 20 °C, 68 °F
(a)
I5JB0B130008-01
S6JB0A1326015
I5JB0B130009-02
I5JB0B130010-01
Boost Pressure Sensor Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Disconnect connector (1) from boost pressure
sensor (2).
3) Remove boost pressure sensor from throttle body to
EGR valve pipe.
Installation
Reverse removal procedure for installation noting the
following.
• Check boost pressure sensor O-ring for damage.
If malfunction is found, replace boost pressure sensor.
• Tighten boost pressure sensor bolt to specified
torque.
Tightening torque
Boost pressure sensor bolt (a): 8 N·m (0.8 kgf-m,
6.0 lb-ft)
S6JB0A1326020
2
1
I5JB0B130011-01
(a)
I6JB0A132002-01