Table of Contents
Advertisement
3) Lower vehicle and install fuel filler cap.
Fuel Tank Inlet Valve Inspection
WARNING
!
Before starting the following procedure, be
sure to observe "Precautions on Fuel System
Service: For Petrol Engine Model" in order to
reduce the risk or fire and personal injury.
Check fuel tank inlet valve for the following.
If any damage or malfunction is found, replace.
• Damage
• Smooth opening and closing
Fuel Tank Removal and Installation
WARNING
!
Before starting the following procedure, be
sure to observe "Precautions on Fuel System
Service: For Petrol Engine Model" in order to
reduce the risk or fire and personal injury.
Removal
1) Relieve fuel pressure in fuel feed line according to
"Fuel Pressure Relief Procedure: For Petrol Engine
Model".
2) Disconnect negative cable at battery.
3) Hoist vehicle.
4) Remove exhaust center pipe.
5) Remove rear propeller shaft referring to "Propeller
Shaft Removal and Installation in Section 3D"
6) With cable connected, detach parking brake cable
clamp from fuel tank cover referring to "Parking
Brake Cable Location in Section 4D"
Fuel System: For Petrol Engine Model 1G-16
7) Disconnect fuel filler hose and breather hose from
filler neck referring to "Fuel Tank Inlet Valve Removal
and Installation: For Petrol Engine Model".
S6JB0A1716014
8) For J20 engine, disconnect fuel pump connector (1).
9) Due to absence of fuel tank drain plug, drain fuel
tank by pumping fuel out through fuel tank filler.
Use hand operated pump device to drain fuel tank.
CAUTION
!
• Do not force pump hose into fuel tank, or
pump hose may damage fuel tank inlet
valve.
• Never store fuel in an open container due
to possibility of fire or explosion.
I5JB0A170009-01
10) Disconnect fuel pipe joint and fuel hoses (1) from
fuel pipes (2) referring to "Fuel Hose Disconnecting
and Reconnecting: For Petrol Engine Model".
S6JB0A1716015
11) Remove fuel tank cover (1).
1
I5JB0A171015-01
2
1
I5JB0A171016-01
1
I5JB0A171017-01
Advertisement
Chapters
Table of Contents
