Oil Pan And Oil Pump Strainer Cleaning - Suzuki Grand Vitara 2011 Manual

3) After fitting oil pan (1) to cylinder block, run in
securing bolts and start tightening at the center:
move wrench outward, tightening one bolt at a time.
Tighten bolts and nuts to specified torque.
Tightening torque
Oil pan bolt and nut (a): 11 N·m (1.1 kgf-m, 8.0
lb-ft)
Transmission case No.1 bolt (b): 85 N·m (8.5
kgf-m, 61.5 lb-ft)
4) Install new gasket and drain plug (2) to oil pan after
applying engine oil.
Tighten drain plug to specified torque.
Tightening torque
Oil drain plug (c): 35 N·m (3.5 kgf-m, 25.5 lb-ft)
(a)
1
(b)
2, (c)
I5JB0A152009-01
Engine Lubrication System: For J20 Engine 1E-16
5) Install front suspension frame referring to "Front
Suspension Frame, Stabilizer Bar and/or Bushings
Removal and Installation in Section 2B".
6) Install engine under cover.
7) Install oil level gauge.
8) Refill engine with engine oil referring to "Engine Oil
and Filter Change (Petrol Engine Model) in Section
0B".

Oil Pan and Oil Pump Strainer Cleaning

• Clean mating surface of oil pan and cylinder block.
Remove oil, old sealant and dust from mating
surfaces and oil pan inside.
• Clean oil pump strainer screen.
S6JB0A1526003