Generator Components - Suzuki Grand Vitara 2011 Manual

1J-12 Charging System: For Petrol Engine Model
Dismounting
1) Disconnect negative (–) cable at battery.
2) Disconnect MAF sensor coupler (For J20 Engine).
3) Remove air cleaner case and air cleaner outlet hose (For J20 Engine).
4) Disconnect generator lead wire ("B" terminal wire) and coupler from generator.
5) Remove generator belt. Refer to "Water Pump and Generator Drive Belt Removal and Installation (For M16
Engine): For Petrol Engine Model" or "Water Pump and Generator Drive Belt Removal and Installation (For J20
Engine): For Petrol Engine Model".
6) Remove generator drive belt adjusting bolt (For M16 Engine) and generator mounting bolt (For J20 Engine) and
generator pivot bolt.
7) Remove generator.
Remounting
1) Mount generator on the generator bracket.
2) Tighten generator mounting bolts and generator pivot bolt as specified torque (For J20 Engine).
3) Install generator belt. Refer to "Water Pump and Generator Drive Belt Removal and Installation (For M16 Engine):
For Petrol Engine Model" or "Water Pump and Generator Drive Belt Removal and Installation (For J20 Engine):
For Petrol Engine Model".
4) Connect "B" terminal wire and coupler to generator.
5) Install air cleaner case and air cleaner outlet hose (For J20 Engine).
6) Connect MAF sensor coupler (For J20 Engine).
7) Connect negative (–) cable at battery.

Generator Components

(c)
10
2
5
1
(a)
1. Pulley nut
2. Pulley
3. Front housing
4. Stator
5. Frame bolt
6
7
8
3
(b)
6. Drive end bearing
7. Bearing retainer
8. Rotor
9. Rear end bearing
10. Retainer screw
13
14
4
9
11. Rear housing
12. Rectifier
13. Regulator
14. Brush
15. "B" terminal
S6JB0A1A16008
15
16 (d)
11
12
I4RS0B1A0007-01
16. "B" terminal nut
: 118 N⋅m (11.8 kgf-m, 85.5 lb-ft)
: 4.5 N⋅m (0.45 kgf-m, 3.5 lb-ft)
: 3.5 N⋅m (0.35 kgf-m, 2.5 lb-ft)
: 8.0 N⋅m (0.8 kgf-m, 6.0 lb-ft)