Oil Pan And Oil Pump Strainer Removal And Installation - Suzuki Grand Vitara 2011 Manual

1E-15 Engine Lubrication System: For J20 Engine
Oil Pan and Oil Pump Strainer Removal and
Installation
Removal
1) Remove oil level gauge.
2) Raise vehicle.
3) Remove engine under cover (1).
4) Drain engine oil by removing drain plug (2).
2
1
5) Remove front suspension frame referring to "Front
Suspension Frame, Stabilizer Bar and/or Bushings
Removal and Installation in Section 2B".
6) Remove oil pan, oil pump strainer (1) and O-ring (2)
from lower crank case.
2
Installation
1) Apply sealant to oil pan (1) mating surface
S6JB0A1526002
I5JB0A152005-01
2) Install new O-rings (2) to oil pump strainer (1)
1
I5JB0A152006-02
continuously as shown in figure.
"A": Water tight sealant 99000–31250 (SUZUKI
Bond No.1207F)
Sealant amount for oil pan
Width "a": 3 mm (0.12 in.)
Height "b": 2 mm (0.08 in.)
"A"
1
securely as shown in figure.
Tighten strainer bolts to specified torque.
Tightening torque
Oil pump strainer bolt (a): 11 N·m (1.1 kgf-m, 8.0
lb-ft)
2
2
"A"
"b"
"a"
I5JB0A152007-01
(a)
1
(a)
I5JB0A152008-02