Main Bearings, Crankshaft And Cylinder Block Components - Suzuki Grand Vitara 2011 Manual

Main Bearings, Crankshaft and Cylinder Block Components

1. Cylinder block
2. Lower crankcase
: Apply sealant 99000-31250 to mating surface.
3. Crankshaft
4. O-ring
5. Oil pump chain
6. Main bearing
: Do not apply engine oil between cylinder block
and bearing, between lower crankcase and
bearing. Upper half of bearing has an oil groove.
7. Thrust bearing
8. Rear oil seal
Engine Mechanical: For J20 Engine 1D-119
9. Check valve
10. Flywheel
11. Water pump
12. Heater outlet pipe
13. CKP sensor
14. Crankcase bolt (10 mm thread
diameter)
15. Crankcase bolt (8 mm thread diameter)
16. Flywheel mounting bolt
S6JB0A1426034
I5JB0A142056-02
17. Knock sensor
: Tighten 40 N⋅m (4.0 kgf-m, 29.0 lb-ft), 0
N⋅m (0 kgf-m, 0 lb-ft), 40 N⋅m (4.0 kgf-m,
29.0 lb-ft) and 58 N⋅m (5.8 kgf-m, 42.0
lb-ft) by the specified procedure.
: Tighten 26 N⋅m (2.6 kgf-m, 19.0 lb-ft) by
the specified procedure.
: 70 N⋅m (7.0 kgf-m, 51.0 lb-ft)
: 11 N⋅m (1.1 kgf-m, 8.0 lb-ft)
: 23 N⋅m (2.3 kgf-m, 17.0 lb-ft)
: Do not reuse.
: Apply engine oil to inside / sliding
surface.