Dtc P0463: Fuel Level Sensor Circuit High - Suzuki Grand Vitara 2011 Manual

Hide thumbs Also See for Grand Vitara 2011:
Table of Contents

Advertisement

DTC P0463: Fuel Level Sensor Circuit High

Wiring Diagram
Refer to "DTC P0462: Fuel Level Sensor Circuit Low: For Petrol Engine Model".
DTC Detecting Condition and Trouble Area
DTC detecting condition
Fuel level sensor voltage is higher than 4.9 V for 3 seconds
continuously.
(1 driving cycle detection logic but MIL does not light up)
DTC Confirmation Procedure
1) With ignition switch turned OFF, connect scan tool.
2) Turn ON ignition switch and clear DTC using scan tool.
3) Start engine and run it for 30 sec. or more.
4) Check DTC and pending DTC.
DTC Troubleshooting
NOTE
Before this trouble shooting is performed, read the precautions for DTC troubleshooting referring to
"Precautions for DTC Troubleshooting: For Petrol Engine Model".
Step
1
Was "Engine and Emission Control System Check"
performed?
2
Does fuel level meter in combination meter indicate "E"
(empty)?
3
Do you have SUZUKI scan tool?
4
Fuel level sensor output signal check with SUZUKI scan
tool
1) Connect SUZUKI scan tool to DLC with ignition switch
turned OFF.
2) Turn ON ignition switch and check fuel level displayed
on SUZUKI scan tool.
Is it 3% or less?
5
Fuel level sensor output signal check
1) Turn OFF ignition switch.
2) Remove ECM from its bracket with ECM connectors
connected.
3) Turn ON ignition switch and measure voltage between
"E23-24" terminal of ECM connector and vehicle body
ground.
Is voltage about 3.5 V or more?
6
Fuel level sensor circuit resistance check
1) Disconnect connectors from ECM with ignition switch
turned OFF.
2) Check for proper connection to "E23-24" terminal of
ECM connector.
3) If OK, measure resistance between "E23-24" terminal of
ECM connector and vehicle body ground.
Is resistance below 280
Engine General Information and Diagnosis: For Petrol Engine Model 1A-150
Action
?
Trouble area
• ECM power and/or ground circuit malfunction
• ECM malfunction
• Fuel level sensor and/or its circuit malfunction
Yes
Go to Step 2.
Replenish fuel tank with
fuel and go to Step 3.
Go to Step 4.
Go to Step 6.
Go to Step 6.
Go to Step 7.
S6JB0A1114049
No
Go to "Engine and
Emission Control
System Check: For
Petrol Engine Model".
Go to Step 3.
Go to Step 5.
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection in Section
00".
Intermittent trouble.
Check for intermittent
referring to "Intermittent
and Poor Connection
Inspection in Section
00".
Go to Step 8.

Advertisement

Table of Contents
loading

Table of Contents