Sensor Plate Inspection; Rear Oil Seal Inspection; Flywheel Inspection; Cylinder Block Inspection - Suzuki Grand Vitara 2011 Manual

Sensor Plate Inspection

Check sensor plate for crack damage.
If malcondition is found, replace it.

Rear Oil Seal Inspection

Carefully inspect oil seal (1) for wear or damage. If its lip
is worn or damaged, replace it.

Flywheel Inspection

Visual Inspection
• If ring gear is damaged, cracked or worn, replace
flywheel.
• If the surface contacting clutch disc is damaged, or
excessively worn, replace flywheel.
Flywheel Face Runout
Check flywheel face runout with a dial gauge.
If runout exceeds its limit, replace flywheel.
Flywheel face runout
Limit: 0.2 mm (0.0079 in.)
Engine Mechanical: For M16A Engine with VVT 1D-61

Cylinder Block Inspection

S6JB0A1416038
Distortion of Gasketed Surface
Using straightedge and thickness gauge, check
gasketed surface for distortion and, if flatness exceeds
its limit, correct It.
Cylinder block flatness
Limit: 0.05 mm (0.0020 in.)
I2RH0B140151-01
S6JB0A1416039
Honing or Reboring Cylinders
1) When any cylinder needs reboring, all other
cylinders must also be rebored at the same time.
2) Select oversized piston according to amount of
cylinder wear.
Oversize piston specification
Oversize 0.50: 78.453 – 78.468 mm (3.0887 –
3.0893 in.)
3) Using micrometer, measure piston diameter.
I4RS0A140020-01
Measurement position for piston diameter
"a": 19.5 mm (0.77 in.)
S6JB0A1416040
4) Rebore and hone cylinder to the following
dimension.
NOTE
Before reboring, install all main bearing caps
in place and tighten to specification to avoid
distortion of bearing bores.
Cylinder bore diameter to be rebored
Oversize 0.50: 78.500 – 78.514 mm (3.0906 –
3.0911 in.)
5) Measure piston clearance after honing.
Piston clearance
0.032 – 0.061 mm (0.0013 – 0.0024 in.)
I2RH01140198-01
S6JB0A1416041
I2RH01140199-01
I2RH01140157-01