Engine Oil And Filter Change (Diesel Engine Model) - Suzuki Grand Vitara 2011 Manual

0B-9 Maintenance and Lubrication:
Engine Oil and Filter Change (Diesel Engine
Model)
WARNING
!
• New and used engine oil can be
hazardous.
Be sure to read "General Precautions in
Section 00" and observe what in written
there.
• Steps 1) – 7) must be performed with
ENGINE NOT RUNNING. For Step 8), be
sure to have adequate ventilation while
engine is running.
CAUTION
!
• Be sure to use specified engine oil. Using
other engine oil will cause engine trouble.
• Do not top up oil over FULL level mark on
dipstick. Too much oil could destroy
engine.
Before draining engine oil, check engine for oil leakage.
If any evidence of leakage is found, make sure to correct
defective part before proceeding to the following work.
1) Drain engine oil by removing drain plug.
2) After draining oil, wipe drain plug clean. Reinstall
drain plug.
Tightening torque
Engine oil drain plug (a): 35 N·m (3.5 kgf-m, 25.5
lb-ft)
3) Loosen oil filter by using oil filter wrench (special
S6JB0A0206043
4) Apply engine oil to new oil filter gasket.
5) Screw new filter on oil filter stand by hand until the
(a)
6) Tighten oil filter (1) 3 / 4 turn from the point of contact
I5JB0B020003-01
tool) accessing from between engine mounting and
radiator outlet hose and from below vehicle.
Special tool
(A): 09915–46510
(A)
filter gasket contacts the mounting surface.
CAUTION
!
To tighten oil filter properly, it is important to
accurately identify the position at which filter
gasket first contacts the mounting surface.
with the mounting surface using an oil filter wrench
(2).
3/4
2
I5JB0B020004-01
I5JB0B020005-01
1,(a)
I5JB0B020006-01