Rep 8.1 Lower Sheet Feed Assembly - Xerox 8850 Service Manual

REP 8.1 Lower Sheet Feed Assembly

Parts List on PL 10.7
Switch off the Printer Power Switch. Disconnect the Printer Power Cord.
Removal
1. Remove the Xerographic Module. Perform
NOTE: In the following steps, the terms "Left" and "Right" describe machine locations as
observed when facing the Printer from the Roll Media Supply Drawer side.
2. (Figure 1): Look down into the area previously occupied by the Xerographic Module. Pre-
pare the left side of the Lower Sheet Feed Assembly for removal.
1
Disconnect P/J A28J1
Figure 1 Preparing the Lower Sheet Feed Assembly for Removal (Left Side)
8850/ 510DP
WARNING
REP 9.1 Xerographic Module.
Lower Sheet Feed Assembly
2
Remove the two mount screws
3. (Figure 2): Prepare the right side of the Lower Sheet Feed Assembly for removal.
1
Remove the two mount screws
A27P1
Figure 2 Preparing the Lower Sheet Feed Assembly for Removal (Right Side)
03/2003
4-25
Repairs and Adjustments
REP 8.1