Pre-Programmed Button Functionality - Lutron Electronics GRAFIK Eye QSGRJ-3P Installation And Operation Manual

Pre-Programmed Button Functionality

The GRAFIK Eye QS controls most lighting loads without special programming. Each
®
unit ships with pre-programmed default settings for the scene and shade buttons. For
load types other than those shown below (dimmable or non-dim), set the load type
before proceeding. See pages 17-18 for instructions on setting load type. See page 28
for instructions on changing scene settings.
OK
1 2
®
Scene Button Pre-Programming
for Dimmable Loads
Scene 1: All zones to 100%
Scene 2: All zones to 75%
Scene 3: All zones to 50%
Scene 4: All zones to 25%
All zones Off
3 4 5 6
Shade Button Pre-Programming
for Sivoia
All shades fully open
All shades to 50%
All shades fully closed
Lower/Raise all shades
(Applies only to units with shade keypads)
OK
QS shades
®
GRAFIK Eye QS Installation and Operation Guide 13
®