Pre-Programmed Button Functionality - Lutron Electronics QSGRJ-3P Installation And Operation Manual

Pre-Programmed Button Functionality

The GRAFIK Eye QS control unit controls most lighting loads without special
®
programming. Each unit ships with pre-programmed default settings for the scene and
shade buttons. For load types other than those shown below (dimmable or non-dim),
assign the load type before proceeding. See the scene setup section for instructions on
changing scene settings.
®
Scene Button Pre-Programming
for Dimmable Loads
Scene 1: All zones to 100%
Scene 2: All zones to 75%
Scene 3: All zones to 50%
Scene 4: All zones to 25%
All zones Off
Shade Button Pre-Programming
for Sivoia QS shades
®
All shades fully open
All shades to 50%
All shades fully closed
Lower/Raise all shades
(Applies only to units with shade keypads)
GRAFIK Eye QS Control Unit Installation and Operation Guide 12
®