Pre-Programmed Button Functionality - Lutron Electronics GRAFIK Eye QSGRN-6PCE Installation And Operation Manual

Pre-Programmed Button Functionality

The GRAFIK Eye QS control unit controls most lighting loads without special
®
programming. Each unit ships with pre-programmed default settings for the scene and
shade buttons. For load types other than those shown below (dimmable or non-dim),
assign the load type before proceeding. See the scene setup section for instructions on
8 16
changing scene settings.
9-16
1-8
OK
1 9 2 10
®
Scene Button Pre-Programming
for Dimmable Loads
Scene 1: All zones to 100%
Scene 2: All zones to 75%
Scene 3: All zones to 50%
Scene 4: All zones to 25%
All zones Off
3 11 4 12 5 13 6 14 7 15
Shade Button Pre-Programming
for Sivoia
All window treatments fully open
All window treatments to 50%
All window treatments fully closed
Lower/Raise all window treatments
(Applies only to units with shade keypads)
8 16
9-16
1-8
OK
QS window treatments
®
GRAFIK Eye QS Control Unit Installation and Operation Guide 13
®