Loading/Replacing Paper; Replacing/Cutting Roll Paper - Xerox Wide Format 6705 System User Manual

1.7

Loading/Replacing Paper

1.7.1

Replacing/Cutting Roll Paper

Load roll paper in the Roll 1 or Roll 2.
Once the paper has been loaded, cut the leading edge of the paper.
Roll paper is heavy. When lifting roll paper, make sure to hold it with both hands, and bend your knees enough so
as not to hurt your back.
Dropping or toppling roll paper may cause injury. Be sure to handle roll paper with extra care.
When loading roll paper, be careful not to pinch your fingers.

Important
When removing the piece of tape holding the edge of the roll paper from unraveling, make sure to completely

remove the adhesive. If the adhesive gets inside the machine, print quality may decrease.
Do not open the Roll 1 or Roll 2 cutter cover.

When loading paper of different type, size, or weight, change the paper settings after you finish loading the

paper. For information on how to do this, refer to "Paper Tray Settings" (p. 293).
Have a new roll paper ready, and replace the old roll paper using the following procedure.
Steps
St
1.
Open the front door.
2.
Pull out the roll unit with both hands.
When you want to just cut the leading edge of the roll

Note
paper without replacing with new roll paper, go to Step
8.
CAUTION

1.7 Loading/Replacing Paper

1
45