Xerox Wide Format 6705 System User Manual page 252

Symptom
Nothing is copied/
printed.
The entire output
is faint.
The copied/
printed image is
misaligned or
skewed.
Part of the copied/
scanned image is
missing.
8
The copied/
scanned output
has shadows.
Image is lost on
the edge of paper.
8.4 Image Quality Problems
252
Check
For a copy job, is the scanned side
of the document facing down?
High-voltage power supply may
have malfunctioned.
Is the toner density appropriate?
Is the media loaded correctly?
Is the document placed correctly?
Is the media loaded correctly?
Are the copy settings such as
Reduce/Enlarge, Paper Supply,
Image Shift, Edge Erase, and Scan
Start Position correct?
Are the copy settings such as
Reduce/Enlarge, Original Size,
Edge Erase, and Scan Start
Position correct?
Is the document a paste-up or
folded original?
Is the document quite transparent
such as a transparency film?
Is part of the image outside of the
printable area?
Remedy
Place the document with the side to be scanned facing down.
Contact your local Xerox representative.
Adjust the toner density.
Refer to "Toner Density" (p. 296).

Refer
Correctly load the media.
Refer to "Loading/Replacing Paper" (p. 45).

Refer
Correctly load the document.
For a copy job, refer to "Step 3 Starting the Copy

Refer
Job" (p. 80).
For a scan job, refer to "Step 2 Starting the Scan

Job" (p. 127).
Correctly load the media.
Refer to "Loading/Replacing Paper" (p. 45).

Refer
Set the copy settings correctly.
Refer to "Reduce/Enlarge (Making Enlarged/

Refer
Reduced Copies)" (p. 102) and "Copy - [Output
Format] Screen" (p. 119).
Set the copy settings correctly.
Refer to "Reduce / Enlarge (Specifying the

Refer
Scanning Magnification)" (p. 156) and "Scan -
[Layout Adjustment] Screen" (p. 155).
Make adjustments under Copy Density, Lighten / Darken, and/or
Original Type.
For a copy job, refer to "Image Options

Refer
(Adjusting the density, sharpness, and contrast
of images)" (p. 109) and "Original Type
(Selecting the Document Type)" (p. 108).
For a scan job, refer to "Image Options

(Adjusting the Scan Density, and Sharpness and
Contrast of Images)" (p. 152) and "Original Type
(Selecting the Document Type)" (p. 139).
Recreate the original so that the image fit to the printable area.
Refer to "Image loss width" in "Specifications" (p.

Refer
344).