Initializing Adjustment Values - Xerox Wide Format 6705 System User Manual

Step 2 Performing Optional Adjustment
Steps
St
1.
Select a registered adjustment value.
Note
1
2.
Press [Save].
Calibration of gaps is performed using the adjustment
values you have set.
Note
1.10.3
Use these steps to restore all of the adjustment values to their factory defaults.
The adjustment values for Auto Adjust are also reset to the factory defaults.

Important
Steps
St
1.
Press [Initialize Value] on the [Scan Sensor Gap Calibration] screen.
2.
Select [Yes].
The adjustment values are reset to the factory defaults.
Note
1.10 Calibrating the Scan Sensor Gap
60
If you choose not to use the registered

adjustment values, select [Off], return to "Step
1: Registering adjustment values" (p. 58), and
set an adjustment value.
After Option Adjust has completed, check the

calibration result by using your documents.
If Option Adjust has failed with an error, take

corrective actions according to the error code, and perform Option Adjust again. For more information on
error codes, refer to "Error Code" (p. 61).

Initializing Adjustment Values

If you choose not to reset the adjustment

values to the factory defaults, select [No].