Problems During Printing - Xerox Wide Format 6705 System User Manual

8.7
This section describes how to troubleshoot problems during printing.
Symptom
Unable to print.
8

8.7 Problems during Printing

258

Problems during Printing

Check
Is the network cable disconnected
from the computer?
Is the network cable disconnected
from the machine?
Is the printer status Offline?
Has an error occurred on the
machine?
Are the IP address and Subnet
Mask set correctly?
Is the network between the
computer and the machine
working?
Is the port enabled?
Is the machine connected to
multiple computers?
Is the media of the specified size
loaded?
Is the Interrupt mode active?
Is a copy or scan job running?
Remedy
Connect the network cable to the computer.
Connect the network cable to the machine.
Check the setting for [Printer Status]. Select [Online] if the status
is [Offline].
Refer to "Print Mode" (p. 66).

Refer
Check the error message, and follow the instructions to solve the
problem.
Set the correct IP address and Subnet Mask.
Refer to "Print Service Settings" (p. 326).

Refer
Consult with your network administrator.
Set the port in use to Enabled.
Refer to "Port Settings" (p. 310).

Refer
Wait for a while, and then try printing again.
Load the specified size media in the machine.
Refer to "Loading/Replacing Paper" (p. 45).

Refer
Switch to another available tray to continue printing.
Refer to "Switching Between Trays" (p. 48).

Refer
Cancel the interrupting operation.
The Print feature cannot be used when the machine is running
the Copy or Multi Send Scan feature.