Xerox Wide Format 6705 System User Manual page 337

Private Charge Print Settings
Allows you to set how incoming print jobs are handled.
When Remote Authentication is enabled, if you select [According to Print Auditron], the settings for [Job Login

Important
Success] and [Job without User ID] are ignored and therefore all print jobs will be printed.
If the machine is set not to use Private Print, [Secure Print] is displayed on the [Services Home] screen, instead of

Note
[Private Print].
Steps
St
1.
Press [Authentication] > [Private Charge Print Settings].
2.
Set each of items.
3.
Press [Save].
According to Print Auditron
Select this to set how incoming jobs should be handled.
The factory default is [According to Print Auditron].
Save as Private Charge Print Job
Select this to store incoming jobs as Private Charge Print
jobs.
Job Login Success
Select this to set how successfully authenticated jobs should
be handled.
When this option is set to [Save as Private Charge Print Job], the Secure Print setting is ignored even when

Note
it is specified in the print driver.
To save a print job as a Private Charge Print job, a User ID must be set using up to 32 single-byte

characters. If the User ID specified in the print driver exceeds the limit of 32 single-byte characters, the
print job is canceled, and therefore is not saved as a Private Charge Print job.
Print Job

Select this to print all incoming jobs. Whether the job is saved as a Secure Print job or is normally printed
depends on the print settings on the client.
Save as Private Charge Print Job

Select this to store incoming jobs as Private Charge Print jobs.
The factory default is [Print Job].
Job without User ID
Select this to set how jobs without an Authentication User ID assigned should be handled.
CentreWare Internet Services can also be used to make these settings.

Note
For information on how to do this, refer to the Help section of CentreWare Internet Services.
Print Job

Select this to print all jobs which do not have an authentication attribute assigned.
Delete Job

Select this to delete all jobs which do not have an authentication attribute assigned.
The factory default is [Delete Job].
9.9 Authentication / Security Settings
9
337