System Settings Procedure; Step 1 Entering System Administration Mode - Xerox Wide Format 6705 System User Manual

9.1
To configure or change the system settings, you must enter the System Administration mode.
This section describes the basic procedures for system settings. Refer to the following setup procedures:
Step 1 Entering System Administration Mode...........................................................................................................................p. 282

 Step 2 Selecting the Desired Item ..................................................................................................................................................p. 283
 Step 3 Configuring a Feature ............................................................................................................................................................p. 284
 Step 4 Exiting System Administration Mode..............................................................................................................................p. 285
9.1.1
To enter the System Administration mode, enter the system administrator User ID. The password is also required
when [Password Entry from Control Panel] is set to [On] in [Authentication] under [Authentication/Security Settings].
We recommend that you change the system administrator user ID and password immediately after the machine has
been installed.
For information on how to change them, refer to "System Administrator Settings" (p. 330).

Refer
9
Steps
St
1.
Press the <Log In/Out> button on the control panel.
2.
Enter the user ID of the system administrator, by using
the numeric keypad or the keyboard displayed on the
screen, and press [Enter].
Note

9.1 System Settings Procedure

282

System Settings Procedure

Step 1 Entering System Administration Mode

By factory default, the User ID is "11111".

The screen may differ depending on the settings

of the machine.
The <Log In/Out> button is lit when the machine

enters the System Administration mode.
Copy (Not In Use) Review
Services Home
ABC DEF
1 2 3
Clear All
Job Status
GHI JKL MNO
4 5 6
Interrupt
PQRS TUV WXYZ
7 8 9
Machine Status
0
＃
Dial Pause Speed Dial
C Start
<Log In / Out> button
Log In / Out
Energy Saver
Stop