Detailed Settings - Xerox Wide Format 6705 System User Manual

9.3.9

Detailed Settings

Steps
St
1.
Press [Detailed Settings].
2.
Fill in [Item Number] and press [Confirm / Change].
For information on the item numbers, refer to

Refer
"Item Number: Common Service Settings" (p.
299).
3.
Fill in [New Value].
4.
Press [Confirm / Change].
Item Number: Common Service Settings
Item
Number
3 Sets the amount of margin in the positive
direction which the machine takes into account
when determining whether the original size is of
a standard/non-standard size.
For example, when 5 mm is set, up to the length
equivalent to a standard size plus 5 mm is
considered as a standard size.
4 Sets the amount of margin in the negative
direction which the machine takes into account
when determining whether the original size is of
a standard/non-standard size.
For example, when 5 mm is set, up to the length
equivalent to a standard size minus 5 mm is
considered as a standard size.
5 Sets the length guaranteed to be scanned when
the machine runs a job such as a copy job for
which Paper Cut Mode - [Synchronized] is
specified or a scan job for which Original Size -
[Auto Detect] is specified.
12 Sets the duration of time before the machine
switches to the plot mode.
14 Sets whether to use the Copy from Memory
function.
Description New Value
0-20 (mm)
0-20 (mm)
0-15 (m)
(When 0 or a value exceeding the
physical memory capacity is
specified, output for the current job
must be completed before
scanning of the next original can
be started.)
3-60 (sec)
0: Disabled
1: Enabled
Factory Default
5 (mm)
5 (mm)
6 (m)
30 (sec)
1: Enabled
9.3 Common Service Settings
9
299