Printer Language, Select; Self-Strip, Enable/Disable; Top Of Form, Set - Intermec 4630 User Manual

4630 and 4830 Bar Code Label Printers User's Manual

Printer Language, Select

Selects the printer language.
Purpose:
Syntax:
<SI>l n
n can be one of the following values:
0 = USA
1 = UK
2 = Germany
3 = Denmark
Default: n = 0
Notes: Only one language is used per print job.
To print 256 Characters or Code Page 850, you must use a parralel interface or
configure the host serial port for 8-bits per byte data transmission.

Self-Strip, Enable/Disable

Purpose: Turns the Self-Strip option on or off. The Self-Strip option must first be
installed from the control panel.
Syntax:
<SI>t n
n = 0
n = 1
Default: n = 0
Notes: This command becomes effective after a printer reset or power up.

Top of Form, Set

Purpose: Sets the top-of-form (left margin) to n which is the distance, in 5 mil
increments, from the label origin to its leading edge.
Syntax:
<SI>F n
n must be a number from -10 to 4000 in 5 mil increments. The negative values
let you decrease the margin and print closer to the edge of the label.
Default: n = 20
6-36
4 = France
5 = Sweden
6 = Italy
7 = Spain
Disables the Self-Strip option.
Enables the Self-Strip option.
8 = 256 Characters
9 = Switzerland
10 = Code Page 850