User-Defined Tables, Transmit; Warm Boot - Intermec 4630 User Manual

User-Defined Tables, Transmit

Transmits the commands the printer would receive to download a new
Purpose:
command set.
Syntax:
<ESC>Z t
t is the command table identifier.
t = 0
t = 1
t = 2
t = 3
t = 4
Notes: Use this command to substitute protocol and command characters. Refer to
"Command Tables" later in this chapter for a listing of default values.

Warm Boot

Resets the printer with a warm boot.
Purpose:
Syntax:
<BS>
Notes: Unlike the <DLE> command, this command does not take effect immediately.
It waits until all previous commands have been executed before it takes effect.
Data sent after this command, or before the printer finishes rebooting, is lost. In
XON/XOFF mode, the printer sends back a <DC2>.
This command is useful when changes in configuration settings require a
printer reset.
Print mode commands
Escape print commands
Shift print commands
Status response
Protocol characters
Print Mode Commands
6
6-29