Mitsubishi PBV20N2 Service Manual page 93

© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All
PBV20N2 PBV20N2
8.1.5 8.1.5 Installing Installing the the accelerator
1. 1. Connect the accelerator wires to Connect the accelerator wires to the accelerator connector. The pin locations
from 1 to 3 are marked on the connector with lines and help you from 1 to 3 are marked on the connector with lines and help you in determining
the rest of the pin locations. Details of the accelerator wires and the rest of the pin locations. Details of the accelerator wires and their pin
locations are available in Figure 54 locations are available in
2. 2. Install the Install the accelerator. accelerator.
3. 3. Install the mounting bracket and tighten the screws. Install the mounting bracket and tighten the screws.
4. 4. Fit the accelerator connector to the mounting bracket. Fit the accelerator connector to the mounting bracket.
5. 5. Install the microswitch bracket. Install the microswitch bracket.
6. 6. Install the safety button. For instructions, see Install the safety button. For instructions, see the section
perform the steps in reversed order. perform the steps in reversed order.
7. 7. Assemble the Assemble the tiller arm. For instructio tiller arm. For instructions, see the se
the steps in reverse order. the steps in reverse order.
8. 8. Calibrate the accelerator. For instructions, see the section Calibrate the accelerator. For instructions, see the section 9.1.
Figure 54. Accelerator pin locations Figure 54. Accelerator pin locations
Table 3. Accelerator wire details Table 3. Accelerator wire details
PIN PIN WIRE WIRE COLOR COLOR
Red/Green Red/Green
1 1
- -
2 2
White/Black White/Black
3 3
White White
4 4
Orange Orange
5 5
Black Black
6 6
White/Brown White/Brown
7 7
https://www.forkliftpdfmanuals.com/
rights rights reserved. reserved. Revision: B Revision: B
accelerator
the accelerator connector. The pin locations
Figure 54 and and Table 3 Table 3 below.
ns, see the section
DESCRIPTION DESCRIPTION
Sensor +24 Sensor +24 V V
- -
Backward signal Backward signal
Forward signal Forward signal
Sensor Sensor GND GND
Sensor Sensor analogue analogue output
Sensor 0 0 V V Sensor
Document ID: 615023 Document ID: 615023
Service Service Manual Manual
in determining
their pin
below.
the section 8.1.3 8.1.3 above, just above, just
ction 5.15 5.15 above, just perform above, just perform
9.1.
output
93 (244) 93 (244)