Table of Contents
Advertisement
© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All
rights reserved.
rights
reserved.
Revision: B
Revision: B
PBV20N2
PBV20N2
6. 6. Pull the truck's tiller to the driving
Pull the truck's tiller to the driving
position and move the lever for lifting
position and move the lever for lifting
and lowering to one end position
and lowering to one end position
and then to the other end position.
and then to the other end position.
7. 7. In TruckTool, check that the displayed values are acceptable and click "Stop".
In TruckTool, check that the displayed values are acceptable and click "Stop".
If the process fails,
If the process fails, update the firmware on the controller and try
update the firmware on the controller and try again.
15.4.3.2 Acquiring the VACC without Truck Tool
15.4.3.2 Acquiring the VACC without Truck Tool
1. 1. During key-o
During key-on, lower the
n, lower the forks and
and hold the buttons down for 15 seconds.
and hold the buttons down for 15 seconds.
The truck enters the accelerator teach-in mode.
The truck enters the accelerator teach-in mode.
2. 2. Release
Release all
all the
the buttons.
buttons.
3. 3. Teach the
Teach the controller for
controller for lifting and
lowering to one end position, then to the other end position.
lowering to one end position, then to the other end position.
4. 4. Release
Release the
the lever fo
lever for lifting
r lifting and
5. 5. Press th
Press the sa
e safety b
fety button
utton to sav
6. 6. Restart
Restart the
the truck.
truck.
https://www.forkliftpdfmanuals.com/
Document ID: 615023
Document ID: 615023
forks and turn the a
turn the accelerator fo
ccelerator forward at the
lifting and lowering b
lowering by moving
y moving the lever
and lowering.
lowering.
to save the
e the settings.
settings.
193 (244)
193 (244)
Service Manual
Service
Manual
again.
rward at the same time
same time
the lever for lifting an
for lifting and d
Advertisement
Table of Contents
