Mitsubishi PBV20N2 Service Manual page 15

© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All
PBV20N2 PBV20N2
Loose or damaged fuel, lubricant and hydraulic lines, tubes and hoses can cause Loose or damaged fuel, lubricant and hydraulic lines, tubes and hoses can cause
• •
fires. Do not bend or fires. Do not bend or strike any high pressure lines or strike any high pressure lines or install ones that have been
bent or damaged. Inspect all lines, tubes and hoses carefully. Pin hole (very bent or damaged. Inspect all lines, tubes and hoses carefully. Pin hole (very small)
leaks can result in a high velocity oil stream that will be invisible close to the hose. leaks can result in a high velocity oil stream that will be invisible close to the hose.
This oil can penetrate the skin and cause personal injury, so This oil can penetrate the skin and cause personal injury, so use cardboard or
paper to locate pin hole leaks. paper to locate pin hole leaks.
• • Tighten connections to the correct Tighten connectio ns to the correct torque. Make sure that all heat shields, clamps
and guards are installed correctly to avoid excessive heat, vibration or rubbing and guards are installed correctly to avoid excessive heat, vibration or
against other parts during operation. Protective shields against oil sprays onto hot against other parts during operation. Protective shields against oil
exhaust components in the event of exhaust compone nts in the event of a line, tube or
correctly. correctly.
Do not operate the truck, if any rotating part is Do not operate the truck,
• •
any other part during operation. Every high speed rotating component that has been any other part during operation. Every high speed rotating component that has been
damaged or altered should be checked for balance before reusing. damaged or altered should be checked for balance before reusing.
rights reserved. rights reserved. Revision: B Revision: B
https://www.forkliftpdfmanuals.com/
torque. Make sure that all heat shields, clamps
a line, tube or seal failure must be installed
if any rotating part is damaged or comes into contact with damaged or comes into contact with
Document ID: 615023 Document ID: 615023
Service Manual Service Manual
install ones that have been
use cardboard or
rubbing
sprays onto hot
seal failure must be installed
15 (244) 15 (244)
small)