Mitsubishi PBV20N2 Service Manual page 127

© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All rights rights reserved. reserved. Revision: B Revision: B
PBV20N2 PBV20N2
4. 4. Install the motor side wires inside Install the motor side wires inside
the cable holder. Make sure that the the cable holder. Make sure that the
cables are in the correct order as cables are in the correct order as
shown in Figure 75 shown in Figure 75 below.
5. 5. Install the cable holder and the Install the cable holder and the
mounting plate to the support, mounting plate to the support,
approximately 10 mm from the cable approximately 10 mm from the cable
tie. tie.
6. 6. Insert Loctite 248 glue to the bolts Insert Loctite 248 glue to the bolts of of
the cable holder. the cable holder.
7. 7. Install the bolts attaching the cable Install the bolts attaching the cable
holder to the support and tighten holder to the support and tighten
them so that the distance from the them so that the distance from the
back of the support to the front of back of the support to the front of
the mounting plate is 37 mm (see the mounting plate is 37 mm (see
Figure 75 below). Figure 75 below).
Figure 75. Correct order of wires inside the cable holder Figure 75. Correct order of wires inside the cable holder
https://www.forkliftpdfmanuals.com/
Document ID: 615023 Document ID: 615023
below.
126 (244) 126 (244)
Service Manual Service Manual