Mitsubishi PBV20N2 Service Manual page 216

© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All rights reserved. rights reserved. Revision: B Revision: B
PBV20N2 PBV20N2
15.11.6 15.11.6 Adjusting the Adjusting the motor be
Figure 107. Motor belt overview Figure 107. Motor belt overview
1. 1.
Motor belt Motor belt
During maintenan During maintenance, check the condition of the ce, check the condition of the motor belt and tighten it, if
The strength of a new motor belt is 206 N. The strength of a new motor belt is 206 N.
• •
When the motor belt is in place and tightened, it should give in approximately When the motor belt is in place and tightened, it should give in approximately
• •
1.8 mm. If the belt gives in more or less 1.8 mm. If the belt gives in more or less than that, adjust it accordingly.
The minimum strength of a used motor belt is 155 N. When the minimum strength is The minimum strength of a used motor belt is
• •
reached, replace the motor belt as instructed in section reached, replace the motor belt as instructed in section 15.11.7.
1. 1. Loosen the motor belt fastener. Loosen the motor belt fastener.
2. 2. Open the nut of the tightening Open the nut of the tightening
screw. screw.
3. 3. Adjust the mot Adjust the motor belt's tightne or belt's tightness as
needed. needed.
https://www.forkliftpdfmanuals.com/
Document ID: 615023 Document ID: 615023
motor belt lt
2. 2.
Tightening screw Tightening screw
motor belt and tighten it, if needed.
than that, adjust it accordingly.
155 N. When the minimum strength is
ss as
215 (244) 215 (244)
Service Manual Service Manual
needed.
15.11.7.