Mitsubishi PBV20N2 Service Manual page 57

© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All
PBV20N2 PBV20N2
Assembly of the load whee Assembly of the load wheel: l:
1. 1. Place the load wheel into the bracket. Place the load wheel into the bracket.
2. 2. Push the bolt through the bracket and the load wheel. Be careful not to damage Push the bolt through the bracket and the load wheel. Be careful not to damage
the bolt threads. the bolt threads.
3. 3. Tighten the bolt holding the load wheel in the bracket. Tighten the bolt holding the load wheel in the bracket.
4. 4. Check that the load wheel rotates properly. Check that the load wheel rotates properly.
5.11 5.11
Lifting system and fork carriage Lifting system and fork
Figure 37. Lifting system and fork carriage overview Figure 37. Lifting system and fork carriage overview
1. 1. Fork carriage shaft Fork carriage shaft
2. 2.
Link Link
3. 3. Chassis shaft Chassis shaft
4. 4. Slide bearing Slide bearing
The lift cylinder handles the lifting of The lift cylinder handles the lifting of the fork carriage, while the
assists in raising the fork tips. For stable lifting, it is assists in raising the fork tips. For stable lifting, it is important that there is not too much
play in the linkage mechanism. Below you can find the play in the linkage mechanism. Below you can find the instructions regarding the
disassembly of the linkage mechanism. Assemble the linkage mechanism by repeating disassembly of the linkage mechanism. Assemble the linkage mechanism by repeating
the steps in reversed order. the steps in reversed order.
rights reserved. rights reserved. Revision: B Revision: B
https://www.forkliftpdfmanuals.com/
carriage
5. 5. Tub pin Tub pin
6. 6.
Push rod shaft Push rod shaft
7. 7. Load wheel fork shaft Load wheel fork shaft
the fork carriage, while the push rod mechanism
important that there is not too much
Document ID: 615023 Document ID: 615023
Service Manual Service Manual
push rod mechanism
instructions regarding the
57 (244) 57 (244)