Mitsubishi PBV20N2 Service Manual page 43

© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All
PBV20N2 PBV20N2
1. 1. Remove the front screw from the Remove the front screw from the
gas spring's triangular mounting gas spring's triangular
plate. plate.
2. 2. Fold the side guard in. Fold the side guard in.
3. 3. Remove the gas spring. Note the Remove the gas spring. Note the
location of the wiring. location of the wiring.
4. 4. Check the condition of the ball joints Check the condition of the ball joints
holding the gas spring in place. holding the gas spring in place.
Replace ball joints, if needed. Replace ball joints, if
5. 5. Install the new gas spring. Make sure Install the new gas spring. Make sure that the location of the wiring
as it was with the old spring. as it was with the old spring.
6. 6. Fasten the front screw on the Fasten the front screw on the triangular mountin
rights reserved. rights reserved. Revision: B Revision: B
https://www.forkliftpdfmanuals.com/
mounting
needed.
that the location of the wiring is the same
triangular mounting plate.
Document ID: 615023 Document ID: 615023
Service Manual Service Manual
is the same
g plate.
43 (244) 43 (244)