Table of Contents
Advertisement
© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All
rights reserved.
rights
reserved.
Revision: B
Revision: B
PBV20N2
PBV20N2
Figure 109. Adjust the steering transmission ratio to 1:1
Figure 109. Adjust the steering transmission ratio to 1:1
15.11.8.4 Steering
15.11.8.4
Steering straight
straight forward
1. 1. With the
With the Zapi hand
Zapi hand console, go
console, go to the
ZONE = ON.
ZONE = ON.
2. 2. Restart
Restart the
the truck.
truck.
When the truck is restarted, there is a 20 degree dead zone in the middle of the
When the truck is restarted, there is a 20 degree dead zone in the middle of the
steering area. Inside this dead zone, turning the tiller does not turn the steering
steering area. Inside this dead zone, turning the tiller does not turn the steering
mechanism.
mechanism.
Be careful while calibrating the straight forward position.
Be careful while calibrating the s
3. 3. Go to
Go to the ADJUSTMENTS menu
the ADJUSTMENTS menu and find
increasing this value, the steering mechanism turns to the left and by decreasing
increasing this value, the steering mechanism turns to the left and by
this value, the steering mechanism turns to the r
this value, the steering mechanism turns to the right.
4. 4. Drive carefully
Drive carefully and adju
and adjust the tiller
possible. Then drive forward and backward to see how straight the truck is
possible. Then drive forward and backward to see how straight the
travelling. If needed, adjust the SET STEER 0-POS. parameter to adjust the
travelling. If needed, adjust the SET STEER 0-POS. parameter to adjust the straight
forward driving.
forward driving.
5. 5. Press O
Press OUT an
UT and E
d ENTER to
NTER to save
6. 6. After
After the
the calibration,
calibration, restart
restart the
7. 7. After the rest
After the restart, the TIL
art, the TILLER DEAD ZO
and the dead zone is no longer present. When the tiller is in
and the dead zone is no
position, make sure that the truck really travels straight forward. If
position, make sure that the truck
calibration steps and restart the truck again.
calibration steps and restart the truck again.
https://www.forkliftpdfmanuals.com/
Document ID: 615023
Document ID: 615023
forward calibration
calibration
to the SET OPTIONS
SET OPTIONS menu and
traight forward position.
and find the SET
the SET STEER 0-POS parameter. By
ight.
st the tiller and the
and the steering m
steering mechanism a
save the
the settings.
settings.
the truck.
truck.
LER DEAD ZONE paramete
NE parameter has turned
longer present. When the tiller is in the straight forward
really travels straight forward. If not, repeat the
219 (244)
219 (244)
Service Manual
Service
Manual
menu and set TILLER DEAD
set TILLER DEAD
STEER 0-POS parameter. By
decreasing
echanism as straight a
s straight as s
truck is
r has turned to the O
to the OFF state
FF state
the straight forward
not, repeat the
straight
Advertisement
Table of Contents
