Mitsubishi PBV20N2 Service Manual page 111

© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All rights reserved. rights reserved. Revision: B Revision: B
PBV20N2 PBV20N2
7. 7. Turn the motor so that the bolt holes Turn the motor so that the bolt holes
of the motor and the transmission of the motor and the
top section are top section are aligned correctly. aligned correctly.
8. 8. Fasten the motor and the Fasten the motor and the
transmission top section with the transmission top section with the
eight cap screws and the locking eight cap screws and the locking
pieces. The tightening torque of the pieces. The tightening torque of the
screws is 23 Nm. screws is 23 Nm.
After replacing After replacing the motor or cont the motor or controller, teach the
wizard or using the following button combination: wizard or using the following button combination:
1. 1. During key-o During key-on, move n, move the tiller arm
release / low speed and safety buttons for release / low speed and safety buttons for 15 seconds.
2. 2. After the After the contactor contactor opens opens and re
8.3.5 8.3.5 Temperature Temperature sensor
The temperature sensor is located inside the motor and cannot be changed. The temperature sensor is located inside the motor and cannot be changed.
The condition of the temperature sensor can be verified with a multimeter. Measure the The condition of the temperature sensor can be verified with a
ohms between the traction motor connector pins XM1/1 and XM1/2. The ohms between the traction motor
be ~580 Ω. Ω.
be ~580
Figure 62 below provides a graphical presentation on how Figure 62 below provides a graphical presentation on how the resistance varies
according to the temperature. according to the temperature.
https://www.forkliftpdfmanuals.com/
Document ID: 615023 Document ID: 615023
transmission
roller, teach the motor resistance motor resistance with the TruckTo
the tiller arm to the d to the driving position riving position and press
15 seconds.
and recloses, re closes, restart the start the truck
sensor check check
connector pins XM1/1 and XM1/2. The value should
110 (244) 110 (244)
Service Manual Service Manual
with the TruckTool ol
and press the brake the brake
truck
multimeter. Measure the
value should
the resistance varies