Mitsubishi PBV20N2 Service Manual page 139

© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All rights reserved. rights reserved. Revision: B Revision: B
PBV20N2 PBV20N2
1. 1. Remove the hydraulic oil hose. Remove the hydraulic oil hose.
2. 2. Remove the hydraulic Remove the hydraulic connector.
3. 3. Unscrew the bolts attaching the Unscrew the bolts attaching the
hydraulic aggregate to the truck hydraulic aggregate to the truck
frame. frame.
4. 4. Remove the Remove the hydraulic aggregate. hydraulic aggregate.
10.4.2 10.4.2 Disassembly Disassembly of of the
To adjust the pressure relief valve or To adjust the pressure relief valve or to clean the hydraulic oil suction filter,
disassemble the oil tank. disassemble the oil tank.
1. 1. Remove the four bolts attaching the Remove the four bolts attaching the
oil tank to the pump motor. oil tank to the pump motor.
2. 2. Remove the oil tank. Remove the oil tank.
3. 3. Adjust the pre Adjust the pressure relief valve ssure relief valve, if
necessary. Note that the pressure necessary. Note that the pressure
relief valve has been factory relief valve has been factory
adjusted and normally there is no adjusted and normally there is no
need for re-adjusting it. need for re-adjusting it.
4. 4. Clean the hydraulic oil suction filter Clean the hydraulic oil suction filter
and the oil tank. and the oil tank.
https://www.forkliftpdfmanuals.com/
Document ID: 615023 Document ID: 615023
connector.
the oil oil tank tank
to clean the hydraulic oil suction filter, you must
, if
138 (244) 138 (244)
Service Manual Service Manual
you must