Table of Contents
Advertisement
© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All
rights
rights reserved.
reserved.
Revision: B
Revision: B
PBV20N2
PBV20N2
15.11.8.5 Final
15.11.8.5
Final adjustment
adjustment
Make sure that the electrically powered steering runs as it should and no errors are
Make sure that the electrically powered steering runs as it
present. ALARM STEER HAZARD is not a relevant error. It is
present. ALARM STEER HAZARD is not a
mechanism is turned to the left or right end limit.
mechanism is turned to the left or right end limit.
Remember to clear the controller alarm log:
Remember to clear the controller alarm log:
1. 1. Go
Go to to ALARMS.
ALARMS.
2. 2. Press ENT
Press ENTER and
ER and OUT,
OUT, and th
3. 3. Exit
Exit the
the menu.
menu.
4. 4. Restart
Restart the
the truck.
truck.
15.11.9 Steering controlle
15.11.9
Steering controller parameter
Table 12. Main menu: parameter change
Table 12. Main menu: parameter change
PARAMETER
PARAMETER
Dynamic numbness angle
Dynamic numbness angle
DYNAM NUMB ANG
DYNAM NUMB ANG
Dynamic numbness speed
Dynamic numbness speed
DYNAM NUMB SPEED
DYNAM NUMB SPEED
Max steering angle limit coarse
Max steering angle limit coarse
1ST ANGLE COARSE
1ST ANGLE COARSE
https://www.forkliftpdfmanuals.com/
Document ID: 615023
Document ID: 615023
relevant error. It is present when the steering
and then p
en press ENTE
ress ENTER twice.
R twice.
r parameter descriptions
descriptions
DESCRIPTION
DESCRIPTION
Dynamic numbness smoothens the operation of the
Dynamic numbness smoothens the operation of the
system with small movements. The dynamic
system with small movements. The dynamic
numbness angle defines the angle difference
numbness angle defines the angle difference
between the tiller and the steered wheel on which
between the tiller and the steered wheel on which
dynamic numbness is applied.
dynamic numbness is applied.
Value range:
Value range:
0: No numbness if the angle between the tiller
0: No numbness if the angle between the tiller
•
•
and the steered wheel is greater than five
and the steered wheel is greater than five
degrees
degrees
9: No numbness if the angle between the tiller
9: No numbness if the angle between the tiller
•
•
and the steered wheel is greater than 60
and the steered wheel is greater than 60
degrees
degrees
Dynamic numbness smoothens the operation of the
Dynamic numbness smoothens the operation of the
system with small movements. The dynamic
system with small movements. The dynamic
numbness speed defines the maximum reduction of
numbness speed defines the maximum reduction of
the motor speed.
the motor speed.
Value range:
Value range:
0: At full
0: At full dynamic numbness
dynamic numbness, the steering motor
•
•
frequency is clamped to 40% of the
frequency is clamped to 40% of the maximum
value.
value.
9: At full dynamic numbness
9: At full
dynamic numbness, the steering motor
•
•
frequency is clamped to 100% of the maximum
frequency is clamped to 100% of the
value.
value.
This parameter defines the steering angle limitation.
This parameter defines the steering angle limitation.
It sets the tiller angle
It sets the tiller angle on which the maximum
steered wheel angle is achieved.
steered wheel angle is achieved.
220 (244)
220 (244)
Service Manual
Service
Manual
should and no errors are
present when the steering
, the steering motor
maximum
, the steering motor
maximum
on which the maximum
Advertisement
Table of Contents
