Mitsubishi PBV20N2 Service Manual page 126

© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All rights rights reserved. reserved. Revision: B Revision: B
PBV20N2 PBV20N2
8.8.1 8.8.1 Installing Installing the the traction
Figure 74. Installing the traction motor cables overview Figure 74. Installing the traction motor cables overview
1. 1. Wire harness Wire harness
2. 2. Protective spiral Protective spiral
3. 3. Cable holder Cable holder
1. 1. Install the cables inside the yellow Install the cables inside the yellow
protective spiral. protective spiral.
2. 2. Stretch the protective spiral to check Stretch the protective spiral to check
that the cables are not twisted inside that the cables are not twisted
it. it.
3. 3. Secure the wire harness inside the Secure the wire harness inside the
protective spiral so that the bend at protective spiral so that the bend at
the controller side is the controller side is approximate
the same as on the motor side. the same as on the
https://www.forkliftpdfmanuals.com/
Document ID: 615023 Document ID: 615023
traction motor motor cables cables
4. 4. Mounting plate Mounting plate
5. 5. Support Support
6. 6. Bolt Bolt
inside
approximately ly
motor side.
125 (244) 125 (244)
Service Manual Service Manual