Mitsubishi PBV20N2 Service Manual page 145

© Mitsubishi Forklift Trucks 2013. All © Mitsubishi Forklift Trucks 2013. All
12 12 Parameter Parameter
rights rights reserved. reserved. Revision: B Revision: B
PBV20N2 PBV20N2
descriptions descriptions
Always use the correct parameter list for Always use the correct parameter list for the specific model you are servicing. The
parameter lists are available from the manufacturer's Web site. parameter lists are available from the manufacturer's Web site.
NOTE: If the truck is equipped with the electrical steering option, the parameter NOTE: If the truck is equipped with the electrical steering option, the parameter
descriptions of the steering controller are available in section descriptions of the steering controller are available in
12.1 12.1
Traction controller Traction controller
Table 6. Main menu, parameter change Table 6. Main menu, parameter change
PARAMETER PARAMETER
Acceleration ramp Acceleration ramp
ACCELER. DELAY Y ACCELER. DELA
Acceleration ramp end s Acceleration ramp end smoothening moothening
STOP SMOOTH STOP SMOOTH
Acceleration smoothening Acceleration smoothen ing
ACC SMOO ACC SMOOTH TH
Brake release cutback speed Brake release cutback speed
H&S CUTBACK H&S CUTBACK
Braking ramp end smoothening Braking ramp end smoothening
STOP BRK SMOOTH STOP BRK SMOOTH
https://www.forkliftpdfmanuals.com/
Document ID: 615023 Document ID: 615023
CAUTION CAUTION
the specific model you are servicing. The latest
DESCRIPTION DESCRIPTION
This parameter determines the acceleration rate of This parameter determines the acceleration rate of
the traction motor in the the traction motor in the standard drive mode.
Value range: Value range:
0.1: Fastest 0.1: Fastest
• •
10: Slowest 10: Slowest
• •
This parameter controls the smoothness when the This parameter controls the smoothness when
direction change ramp is stopped. direction change ramp is stopped.
Value range: Value range:
3 Hz: Minimum 3 Hz: Minimum
• •
20 Hz: Maximum 20 Hz: Maximum
• •
This parameter controls the smoothness of the This parameter controls the smoothness of the
acceleration ramp. acceleration ramp.
Value range: Value range:
1: Minimum 1: Minimum
• •
5: Maximum 5: Maximum
• •
This parameter controls the speed reduction when This parameter controls the speed reduction when
the brake release is activated. the brake release is activated.
Value range: Value range:
10%: Enabled 10%: Enabled
• •
100%: Disabled 100%: Disabled
• •
This parameter controls the smoothness when This parameter controls the smoothness when the
braking ramp is stopped. braking ramp is stopped.
Value range: Value range:
• •
3 Hz: Minimum 3 Hz: Minimum
20 Hz: Maximum 20 Hz: Maximum
• •
144 (244) 144 (244)
Service Manual Service Manual
section 15.11.9. 15.11.9.
standard drive mode.
latest
the
the