Table of Contents
Advertisement
T24-ANTD
This option is intended for applications where the antenna must be mounted away from the radio module either
on the outside of a large enclosure or equipment cabinet or on an external surface. It is fitted with a 600 mm long
feeder terminated in a RPSMA plug.
Mounting
Mounting requirements are a 10 mm diameter hole through a maximum material thickness of 3.0 mm if the nut
and shake-proof washer are used, or thicker if the self-adhesive pad alone is used. It should be oriented so that
the broad face points toward the remote device i.e. if it is to link to devices passing overhead then the broad face
should be uppermost. Dimensions: 53 mm diameter, 19 mm puck height, 6 mm stud length
Specification
Gain: 3.0 dBi
Type: Inverted F Printed circuit antenna
Connection: 0.66 m cable terminated in reverse polarity SMA plug (RPSMA Plug)
Environmental Protection: IP69K
Mantracourt Electronics Limited
431
T24 Telemetry User Manual
Advertisement
Table of Contents
