Mantracourt T24 User Manual page 161

d. The entire wind speed sensor should be located so that the cups are fully exposed to the wind and so
that the sensor rotates freely at all boom angles. Avoid mounting the sensor where objects have created
wind turbulence.
Screw the mounting pivot bar to the boom using the 25 mm deep M8 thread or alternatively weld the bar

to the boom. Note that angle iron can be used to extend the mounting position to be clear of the top of
the boom.
Re-fit the wind speed sensor to the bar, add the M8 washer and fit the split pin/cotter pin.

Mantracourt Electronics Limited
160
T24 Telemetry User Manual