Table of Contents
Advertisement
Operation
View readings
As long as the transmitter module is on the same radio channel and share the same Group key settings as the
handheld you will be able to view the reading once the handheld is turned on.
If you need to change the channel of the transmitter module you will need to use the T24 Toolkit software or see
Pairing later in the manual.
Each time you press the Next key
modules. The Data Tag of the selected module will be displayed briefly before the reading is displayed.
To view the Data Tag of the currently viewed module press and hold the next key
Data Tag will be displayed and the reading will remain that of the current module without stepping on.
Keys
Indicators
SIG LOW
BATT LOW
REMOTE ERROR
REMOTE BATT LOW
Mantracourt Electronics Limited
the handheld will cycle to the next transmitter module in its list of detected
Power Key - Press and hold the power key for approximately 2 seconds then
release the key.
This will toggle between turning the handheld on and off.
Can also be used, by giving a quick press, to reset the Auto-Sleep delay.
Next Key – Pressing and releasing selects the next transmitter to view.
Pressing and holding will display the currently viewed transmitter Data Tag
without moving to the next transmitter.
The radio signal from the transmitter module is low. The module is still
functioning but the limit of the range may be near. Communications may start to
deteriorate when this indicator is visible. Until ------ is displayed the
communications are still OK and the display can be relied on for accuracy.
Even with a degraded signal the display value will always be
correct.
The batteries in the handheld are low and need to be replaced.
The transmitter module has an error that the handheld does not recognise.
The battery or supply to the transmitter module is low.
for around a second and the
210
T24 Telemetry User Manual
Advertisement
Table of Contents
