Radio Settings - Mantracourt T24 User Manual

Radio Settings

Here you can change the channel and group key for the base station.
This may be useful if you intend to do any of the following:
Communicate with the T24 modules using your own software

Want to soft pair to a module.

You do not usually need to change these settings because when you 'Pair' to a module to
configure it, the base station is automatically configured to match the radio settings of that
module.
Items you can change:
Channel
Group Key
Advanced
Mantracourt Electronics Limited
Select a channel between 1 and 15. The default is channel 1. You can use the
Spectrum Analyser mode to determine a good clean channel to use.
This section will only be visible if the version of the base station supports
Group keys.
Only modules with identical group keys can communicate. You can isolate
groups of modules on the same channel or just use the key to ensure the data
cannot be read by somebody else.
To use modules that support Group Keys with older modules that do not
then the Group Keys must be blank.
See Advanced Settings below.
364
T24 Telemetry User Manual