Table of Contents
Advertisement
Display Format
Here you can adjust the display.
Items you can change:
Format & Resolution
Leading Zero
Suppression
Overload Limit
Timeout
Advanced
Mantracourt Electronics Limited
Here you can define how the values are displayed on the LCD. There are 7 digits
available and you can define where the decimal point is shown by entering numerals
where a zero indicates a numeric digit position.
When the data is being displayed the number of decimal places you define may be
overridden as the display will always show the correct number of integer digits.
Example: If you set the format to 000.0000 and the value to display is 1000.1234 the
display will show 1000.123
You can also define the resolution, which is the block size of changes to the display.
Example: If you enter the format as 000.0005 the display will only change in steps of
0.0005 which can be used to mask noisy digits at high resolutions.
This can be turned on or off and will suppress leading zeroes when on.
Example:
Leading zero suppression off gives a reading of 000.123
Leading zero suppression on gives a reading of 0.123
You can enter a limit here above which 'Overload' will be shown on the display instead
of the actual value. Applies to the gross input value including any custom scaling.
Enter zero to disable this feature.
Enter the timeout in seconds. This sets the time allowed without any data arriving from
the viewed module before '--------' is displayed on the LCD. Should be at least 3 times
the interval between the data being transmitted by the transmitter module.
This opens the advanced page where you can scale the displayed data.
185
T24 Telemetry User Manual
Advertisement
Table of Contents
