Table of Contents
Advertisement
Operation
Keys
T
Modes
Pairing
Indicators
G
NET
SIG LOW
BATT LOW
REMOTE ERROR
REMOTE BATT LOW
Errors
Mantracourt Electronics Limited
Power Key - Press and hold the power key until the display shows BUSY then
release the key.
Can also be used, by giving a quick press, to reset the Auto-Sleep delay.
Tare Key - This will toggle between gross and zeroed net mode. i.e. If the display
shows gross then pressing the key will zero the display. Pressing the key when in
net mode will return the display to gross mode. The Gross and Net modes are
indicated as described below. Gross and Net are retained through power off.
When you want to use the T24-HS with a different transmitter module you use
pairing. (Ensure that the transmitter module is unpowered for at least 10 seconds.)
Press and hold the Power key then while still holding down the power key press
and hold the Tare key.
Hold both keys until you see PAIRING on the display.
Release the keys and apply power to the transmitter module.
When pairing, the channel and group key settings on the
transmitter module are changed to match those on the T24-
HS.
The display is showing Gross weight.
The display is showing Net weight.
The radio signal from the transmitter module is low. The module is still
functioning but the limit of the range may be near. Communications may start to
deteriorate when this indicator is visible. Until ------ is displayed the
communications are still OK and the display can be relied on for accuracy.
Even with a degraded signal the display value will always be
correct.
The batteries in the handheld are low and need to be replaced.
The transmitter module has an error that the handheld does not recognise.
The battery or supply to the transmitter module is low.
180
T24 Telemetry User Manual
Advertisement
Table of Contents
